Example for the applying of rear window spoiler
The fitting must be done by professionals!
1.Clean the area of fitting.
1.Put the spoiler on the place where it should be installed. Pre-fit the spoiler if necessary. Wrap around the spoiler with paper scotch.
3. Sand the inside part of the spoiler with sandpaper about P60.
5. Apply the primer on the spoiler.
6. Apply the primer on the car.
7. Apply the polyurethane silicone on the inside edge of the spoiler. The silicone should be higher than the edge of the spoiler.
8. Put the spoiler on the car. If there is silicone over the tape wipe it.
9. Remove the tape.
10.Fix the spoiler with paper tape for about 24 hours until the silicone gets dry.